MSDS
October 1, 1995 |
Section 1 Product Information |
Product Name "Iron Hammer" oven cleaner 0 = Least 1 = Slight 2 = Moderate 3 = High 4 = Severe
Hazard Rating Health 2 |
Manufacturer's Name
Hunter’s Sales, Inc. |
Company Address |
Company Phone
(478) 763-2564 |
Company Fax (478) 763-3796 |
Emergency Phone (888) 349-2436 |
Section 2 Physical Data Appearance |
Appearance . . . . . . . . . . . . . . . . . . . . .
clear liquid Specific Gravity . . . . . . . . . . . . . . . . . . .05 - 1.0 Solubility in Water . . . . . . . . . . . . . . . . complete Vapor Press mm hg a 20 Cel . . . . . . . . not established Boiling/Melting Point . . . . . . . . . . . . . . 220 - 280 F (boiling pt.) Vapor density . . . . . . . . . . . . . . . . . . . heavier than air Evaporation rate . . . . . . . . . . . . . . . . . slower than n-butyle acetate Percent volatile by weight (%) . . . . . . . <.05 Hazardous Ingredients**Exposure Limits CAS # Ingredient TLV OSHA-PEL 111-76-2 Ethanol, 2-butoxy 25-PPM 50-PPM 310-73-2 Sodium hydroxide 2 mg/m3 15 PPM 15 PPM |
Section 3 Health Hazard Data |
Routes of Exposure: Exposure may be by INHALATION and/or SKIN or EYE
contact, depending on conditions of use. To minimize exposure, follow
recommendations for proper use - ventilation and personal protective
equipment. ACUTE HEALTH HAZARDS Inhalation: High concentrations are slightly irritating to the eyes and respiratory tract. Skin Contact: Corrosive. Chemical and possible corneal injury, burns. Prolonged and widespread contact, as with chemical saturated clothing can cause reddening, swelling and damage to the skin. The use of chemical resistant gloves is recommended. Glove types are: rubber, latex, plastic. Do not use leather or wool gloves. Penetrates skin readily. Frequent or widespread contact may result in the absorption of potentially harmful amounts. Signs and symptoms of toxicity are similar to those of swallowing. Swallowing: Corrosive. Possible spasms. Vomiting, tissue destruction. Possible fatal injury. Eye Contact: Causes severe corrosive damage and possible blindness if not treated immediately. CARCINOGENICITY: The components in this product are not considered to be a carcinogen by the National Toxicology Program, the International Agency for Research on Cancer or the Occupation Safety and Health Administration. |
Section 4 Emergency First Aid INHALATION |
INHALATION Remove from exposure, get medical attention if
necessary. SKIN CONTACT Remove contaminated clothing and wash with water.(*note, a simple water rinse is not adequate to remove this product from the skin. Continue to water, flush until slipperiness is gone.) INGESTION Drink plenty of water or fruit juice. DO NOT INDUCE VOMITING! Get immediate medical attention. EYE CONTACT Flush with water for 10 - 15 minutes, including under the eyelids. Seek medical attention. . |
Section 5 Fire Fighting Measures |
Flash Point
not established Unusual Fire and Explosion Hazards . . Keep containers closed. Isolated from heat or electrical equipment, and open flames. Closed containers may explode upon exposure to extreme heat. During emergency conditions overexposure to decomposition products may cause a health hazard. Symptoms ma not be immediately apparent. Obtain medical attention. |
Section 6 Soils or Leak Procedures |
Protective clothing and equipment must be worn by clean-up personnel. Contain spillage or leakage in suitable container or contain in a holding area. A temporary holding area may be formed with an earthen dike system. Do not allow drainage to reach sewers, streams or storm conduits. Recover with vacuum equipment such as a septic tank truck or neutralize with weak acid solutions and flush with water. Avoid splashing or misting which could increase health hazards. |
Section 7 & 8 Precautions for Safe Handling & Use/Personal Protection |
Respiratory Protection . . . . . . . none normally required
w/adequate ventilation Ventilation . . . . . . . . . . . . . . . . local exhaust is recommended, general mechanical ventilation is adequate Protective Clothing . . . . . . . . . . gloves, coveralls, aprons, boots, as needed to prevent skin contact Eye Protection . . . . . . . . . . . . . safety glasses or goggles should be worn in all industrial operations Handling Instructions: Handle as corrosive liquid as appropriate. Avoid eye contact and prolonged contact with the skin. Use adequate ventilation. Wash thoroughly after handling |
Section 9 Physical & Chemical Properties |
(See Section 2, page 1) |
Section 10 Reactivity Data |
Product
Stability stable Chemical Incompatibility This product is alkali and not compatible with strong acids Hazardous Decomposition If used in tank cleaning applications this material, upon contact with certain food products or their residues which contain reducing sugars may react to form carbon monoxide gas. Proper tank entry and occupancy procedures should be observed. Monitor the tank atmosphere for the presence of carbon monoxide. Under fire conditions this material will not support combustion. However, it may react with certain metals to form flammable hydrogen gas. Hazardous Polymerization will not occur |
Section 11 Toxicology Information |
This product is a strong alkali and as such is destructive to tissue. See Section 4 for specific first aid measures. |
Section 12 Ecoloalcal information |
NO ADVERSE ECOLOGICAL INFORMATION KNOWN |
Section 13 Disposal Considerations |
Comply with all applicable governmental regulations on spill reporting and handling of disposal wastes. |
Section 14 Transport Information |
This product is a class 3 corrosive material and should be placarded according to all applicable DOT regulations. |
Section 15 Regulator Information |
This product contains the following toxic chemicals subject to the
reporting requirements of Section 313 of the Emergency Planning and
Community Right-To-Know Act of 1986 (40 CFR 372). CAS # Chemical Name Percent by Weight NONE This information should be included in all MSDSs that are copied and distributed for this material. |
Section 16 Other Information |
This information is drawn from recognized sources believed to be reliable. Hunter’s Sales, Inc. makes no guarantees or assumes any liability in connection with this information. The user should be aware of changing technology, research, regulation and analytical procedures that may require changes herein. The data in this MSDS is supplied upon the condition that persons will evaluate this information and then determine its suitability for their use. Complies with Ansi 2400-1. Only USA regulations apply to the above. |